Owner manual

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Document # P36087 Rev. C
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
www.BAND-IT-IDEX.com
Page 1 of 4
C08569
Bantam Hand Tool
Operating
Instructions
Nose of Tool
Tension Release Levers
Winding Mandrel
Ratchet Handle
Cutter Handle
Winding Knob
(Also Hammer Surface)
1. Place end section of band in
open slot of tool nose and
winding mandrel.
2. To apply tension to band,
move ratchet handle back and
forth. Hold tool with cutter
handle.
3. To complete clamp, roll tool
forward and trim band with
cutter and tap down ears of clip.

Summary of content (4 pages)