Owner's manual

Document # I17796 Rev F
© Copyright
BAND-IT-IDEX, Inc. 2009
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-0307 USA
P: 1-800-525-0758 F: 1-800-624-3925
20 of 38
IT6000-AB
3/8” Tie-Lok
®
Tool
Symptom Probable cause Recommended Fix Page
Control Module air pressure
valve is in "off" position.
Rotate Control Module shut-off valve to open position.
Verify gauges read air pressure and check all air
connections for leaks.
5
Pinched coil hose line
Loosen fitting on coiled hose assembly where it enters
tool body.
6
Kinked or pinched air line
Remove right side handle and inspect air lines.
Remove and replace as required.
28
Tension piston interference
with hanger screw holes.
Loosen Hanger Screw on top of tool. Thread
engagement cannot exceed .125 in.
9
Control Module air pressure
valve is in "off" position.
Rotate Control Module valve to open position. Verify
gauges read air pressure.
5
Clamp tail inside tool
Remove clamp tail, if jammed remove
maintenance/flip cover and remove clamp material.
15-17
Knife is in down position.
Remove or replace knife. Verify missing and or
damaged linkage.
23
Wrong clamp type for tool Verify proper tool for selected clamp. Cover page
Handle will not
adjust
Handle nut is
damaged/misaligned.
Remove handle assembly and inspect nut/housing for
damage. Replace as required.
9
Tool will not
operate when
trigger is
depressed
Clamp will not
insert into tool
* = for additional assistance, contact BAND-IT
Troubleshooting
Matrix