Operating instructions

P44987 Revision “B“ Page 10 of 10
UL9010 Electric Ultra-Lok Tool
Trouble-Shooting
1. Lock slips down in buckle: Tighten blade mounting screws. If lock on clamp is still not adequate,
reduce tension on tool by setting torque control knob to a lower number or reduce speed of the drill.
(See “Setting up proper tension”)
2. Drill makes loud, rapid clicking noise: Make sure hammer drill setting is off on drill. (Hammer
symbol on selector knob pointing to back)
3. Drill makes whining noise when clamp gets tight: Safety clutch is dis-engaging inside the drill on
high torque setting (usually 9 or +). Turn torque control knob setting to a lower number and lubricate
tension screw.
4. Anti-Jam clutch between drill and tool releases prematurely: Make sure tool is fully seated on
drill (Loosen clamping screw and re-tighten while pressing tool into drill). If problem still remains,
replace tension screw (Band-It #M00987)
5. Note:To prevent over-travel clutch wear, do not over-use. When tensioning clamp, let drill switch go
as tension block nears its end of travel. Reverse drill and send tension block all the way
forward for a second pull on the band.
Band-It Tool Guarantee and Conditions
Band-It tools are guaranteed against
defective workmanship and/or materials for
a period of one year from date of purchase.
This guarantee is void if tools are altered or
abused in any manner, including lack of
lubrication, or used for any purpose or in any
way not specifically covered by the
instruction packed with each tool.
A
ny performance data published herein is
based on laboratory tests which cannot
duplicate conditions that may be
encountered in field installations. Such
conditions may vary results substantially
from those shown, such as abuse in
handling and installation; failure to follow
recommended handling and installation
practices; abnormal environmental
conditions; neglect of operating condition of
Band-It tools or non-recommended
combinations of Band-It products. Band-It
IDEX, Inc. cannot be responsible for
performance characteristics resulting from
such variables. Representations by any
person of performance data other than as
set forth herein or otherwise in writing by
Band-It IDEX, Inc. are unauthorized and are
at customers risk.
This is Band-It’s sole warranty and is in lieu
of all other warranties, expressed or implied,
which are hereby excluded, including in
p
articular all warranties of merchantability o
r
fitness for a particular purpose. Band-It
shall not be liable for any loss, damages or
expenses directly or indirectly related to the
use of its tools or from any other cause or
for consequential damages. It is expressly
understood that Band-It is not responsible
for damage or injury caused to other
products, property, or persons by reason of
the use of its tools.
Band-It IDEX, Inc. reserves the right to
change and/or improve any Band-It product
without notice.
Band-It products are available from your
local authorized Band-It distributor at prices
and terms established individually by them.
Consult your local authorized distributor for
immediate delivery from local stock.
Metabo Drill is covered solely by
the Metabo warranty as described in
the Metabo literature. Band-It does
not extend any warranty of any kind
to the drill.
Ultra-lok clamps and tools are covered under one or more of the following U.S.
patents: 5,123,350 5,303,571 5,322,091 5,452,523 5,127,446 5,483,998
other U.S. and foreign patents are pending.
BAND-IT-IDEX, INC
A Unit of IDEX Corp
P.O. Box 16307
Denver, Colorado 80216-0307 USA
1-188-525-0758
[e-mail] / www.band-it-idex.com