Operating instructions

P44987 Revision “B“ Page 3 of 10
Keep handle all the way down when applying clamps. Make sure tension block is
all the way forward against the tool head. Set the drill up for right-hand rotation.
Insert clamp tail fully into tool through the tool head. Position the clamp at intended
location and fully depress the actuator switch on drill. Gripper in tension block
automatically engages clamp tail. Tension is applied when tension block stalls
under load and red torque indicator light glows on drill. Push the handle all the way
forward to a solid stop to form a lock and cut off clamp tail. Check to see if lock on
clamp is adequate. Always tap down buckle shroud on completed clamps.
Return handle down. Reverse switch on drill. Feed excess band out of
tool, while tension block is returning to its original position. Reverse switch again
and tool is ready for the next clamp.
Important: if tension block comes near its end of travel, release actuator
switch and reverse drill to pull more on clamp tail. Excessive use of
disengaging clutch indicated by a loud ratcheting sound leads to
premature wear of tension screw.
If clamp does not get tight on first pull, reverse drill and reset tool for
more pull. When re-applying tension, be sure to leave approximately
1.5 inch gap between tool head and buckle to ensure adequate thread
engagement between tension block and screw.
UL9010 Electric Ultra-Lok Tool
Operating Instructions
For more pull,
reset tool and
start 1.5 inches
from buckle to
tighten clamp.
3. Push handle all the way
down. Reverse drill and
feed clamp tail out of tool.
Do not force tool against
clamp, it may result in a
folded clamp tail.
4. Break away clamp
tail by bending it up
and down. Tap
down buckle shroud
to complete clamp.
1. Keep handle all the
way down when applying
tension to clamp tail.
Tighten clamp until drill
stalls.
2. Push handle all the way
forward to form lock. Do
not force past a solid stop.