Operating instructions

P44987 Revision “B“ Page 8 of 10
1. Approximately every 500 clamps, lubricate tension screw with
molybdenum disulfide lubricant, or equivalent.
Make sure tension block is all the way forward against the tool head.
Remove cap from syringe and insert tip of syringe into slot on top of tool
body. Press the tip against the tension screw just behind the tension block
and squeeze out approximately ½” long bead of lubricant. Remove
syringe, and actuate tool without a clamp a couple of times to spread
lubricant evenly on tension screw.
To order more lubricant, specify Band-It #C23199
3. To gain access to bearing components: remove blade mounting
screws (2 places) and slide blade free. Paper clip may be used to
push bearing components out of blade. Wipe lubricant from
components. If ball or bearing tips appears heavily worn, replace with
new one. Note: ¼” ball is made from hard tungsten carbide material,
do not replace with regular ball bearing. (Smooth indention from ball
in the bearing tips is normal).
To re-assemble bearing components: wipe blade cavity clean. Push
small bearing tip into cavity. Apply lubricant to ball and push into
cavity and fill remaining space with lubricant. Push load bearing tip
firmly into blade, some lubricant will be squeezed out. Re-attach
blade to tool head, making sure that load bearing tip extends into
tension screw. While turning mounting screws into blade, push on
blade rearwards. Tighten screws to approximately 120 in-lbs.
4. When replacing worn blade, follow instructions above to properly re-
assemble bearing components.
UL9010 Electric Ultra-Lok Tool
Maintenance Instructions
2. Every 500-1000 clamps, depending on tension setting, inspect and
repack front bearing with same lubricant. Turn load bearing tip and
small bearing tip around 180° for a new bearing surface.
Small Bearing Tip
item 14
¼” Ball
item 15
Load Bearing Tip
item 16
A
ccess Hole to push
out components (use
paper clip)
Blade
item 2
Blade Cavity,
must be packed
with lubricant.
Tension
Screw
item 7
Bearing Detail
Blade Mounting
Screws
item 22