Operating instructions

P44987 Revision “B“ Page 9 of 10

UL9010 Electric Ultra-Lok Tool

Maintenance Instructions

5. To replace gripper: Make sure tension block is all the way forward against the tool head.

Remove one side of the tool body or the other, not both. Slide gripper out sideways and replace

with a new one. Re-attach tool body side. Caution: Do not push drill switch or move tension

block while gripper is out of tool.

6. To replace tension screw: Move tension block all the way back, using drill in tensioning mode

(right hand turn). Remove tool from drill by loosening clamping screw. Remove blade and load

bearing tip from tensioning screw (see bearing detail). Remove one side of the tool body or the

other, not both. Grasp the smooth barrel on tension screw and pull all the way forward until

tension block is against the tool head. If tension screw is stuck, use a punch and tap the center

of the screw from the back end of the tool. Turn tension screw out of tension block. Lubricate

new tension screw with Molybdenum Disulfide lubricant, or equivalent. Install new tension screw

in reverse order, making sure that back end of tension screw extends well beyond the back end

of the tension block. Push the assembly all the way back and extend to round portion of the

tension screw through holes on the tripper bracket and back guide plate. Reinstall tool body side.

Reinstall blade and tighten the blade mounting screws. Reattach tool to drill and drive tension

block all the wa

forward.

Note: Drills needing repair must be forwarded to an authorized ‘Metabo’ repair center in your area.

Be sure to remove Band-It adapter clutch from drill.

Use of Alternate Drills

CAUTION !

The UL9000 tool is designed to work mounted to Metabo drill Model

1015. Use of any other drills in place of the Metabo 1015 may result

in unsatisfactory performance, hazards to the operator and/or the

tool, or unsafe clamps. Use of alternate drills must be approved in

writing by the Vice-President of Product Engineering at Band-It-Idex,

Inc. Disregard of this caution voids the warranty of the tool and

releases Band-It of any and all liabilities arising from such misuses.

Tool Head

item 1

Move tension

block all the way

forward against

the tool head

Gripper

item 8

Tension

Screw

item 7