Installation Instructions

If the required course change to the next waypoint in a route is
more than the set limit, you are prompted and must acknowledge
the course change before the autopilot will turn the vessel.
Fuel setup
The fuel utility monitors a vessel's fuel consumption. This
information is totaled to indicate trip and seasonal fuel usage, and is
used to calculate fuel economy for display on instrument pages and
the data bar.
To use the utility, a Navico Fuel Flow sensor, or a NMEA 2000 engine
adaptor cable/gateway with Navico Fuel Data Storage device must
be fitted to the vessel. Neither the Navico Fuel Flow sensor, nor the
Suzuki engine interface require the use of a separate Fuel Storage
device. Refer to the engine manufacturer or dealer for information
on whether or not your engine provides a data output, and what
adaptor is available to connect to NMEA 2000.
Once the physical connection is made, ensure source selection is
completed. Multiple engine installations using Fuel Flow sensors, or
Fuel Data Storage devices, require setup of related engine location
in the Device list. For general source selection information, refer to
"Source selection" on page 22.
Ú
Note: Multiple engines using a single gateway do not work
with the Navico Fuel Storage device.
Vessel setup
The Vessel setup dialog must be used to select the number of
engines, the number of tanks and vessel’s total fuel capacity across
all tanks.
Software Setup | Vulcan Installation Manual
35