User's Manual
Table Of Contents
- Package Contents
- Installation
- Using Web-based Management
- Login
- Status
- System
- Services
- Network
- Interfaces
- Hotspot
- Mobile Internet
- WWAN Setting
- Network Settings
- Reset Modem
- Manually Update Phone Number
- Manually Update MSID
- Manually Update MIP Profile
- eHRPD Menu
- Enable LTE
- U/SIM PIN Management
- Scenario 1: No mobile internet service
- Scenario 2: Mobile internet service pending
- Scenario 3: Mobile internet service enabled
- SIM Management
- Scenario 1: SIM lock absent
- Scenario 2: SIM lock present
- Preferred Network
- AT command
- Router
- WiFi
- Switch
- Diagnostics
- Firewall
- UPNP
- VPN
- Help
- Logout
- Appendix A: Vehicle Installation Guide
- Appendix B: FAQ
- Appendix C: Specifications
- Appendix D: Important Safety Information and Glossary
Using Web-based Management
45
Passthrough:
to establish a connection to an enterprise network. To
allow PPTP tunnels to pass through the Router, click
Enabled.
L2TP
Passthrough:
Layer 2 Tunneling Protocol (L2TP) is an extension of
the Point-to-Point Tunneling Protocol and is also used
to establish virtual private networks. To allow L2TP
tunnels to pass through the Router, click Enabled.
WiFi
This submenu item is for configuring all Wi-Fi-related settings. This router
initially has the default WiFi SSID. The default SSID and password are as
follows:
Tab Name Corresponding SSID Default Password
“BR_LTE_xxxx” BR_LTE_xxxx
Please refer to your K530’s
SSID/WPA sticker for the
default password.
Note:
1. “xxxx” refers to the last four digits of this router’s MAC address.
For example, if the router’s MAC address is 0026FA0B314A, then
its corresponding SSID is BR_LTE_314A.
2. Initially this router has only the default SSID enabled. The Dual
SSID feature can be enabled in the Advanced Settings tab under
the setting Device Configuration.
Please click after making any changes in this submenu.
Device Configuration
General Setup