User's Manual
Table Of Contents
- Table of Contents
- Package Contents
- Installation
- Wizard Setup
- Internet Setup
- Router Setup
- WiFi Setup
- Basic WiFi Network
- Basic WiFi Network
- Open System
- WEP: The Router supports two WEP (Wired Equivalent Privacy) standards: 64-bit and 128-bit. Select a standard from the drop-down list. The 64-bits encryption requires 10 hexadecimal digits (letters a-f and numbers 0-9 are valid). The 128-bits encryptio...
- 802.1x
- WPA2
- WPA PSK
- WPA2 PSK
- WPA - WPA2 - Mixed PSK
- Basic WiFi Network
- Basic WiFi Network
- 4G LTE Setup
- Security Setup
- Status
- Telephony
- Appendix A: FAQ
- Appendix B: Specification
- Appendix C: Important Safety Information and Glossary
Package Contents
5
Hardware Overview
1
4G External
Antenna Port
To connect the main 4G External Antenna if
needed.
2
Reset Button
To reset the Router, press the reset button
briefly.
To restore the Router's factory settings, press
the reset button for longer than 5 sec.
3
LAN Port
Connect Ethernet devices such as computers,
switches, and hubs.
4
W A N Port
Connect a DSL or Cable modem.
5
RJ11 Port
Connect an analog phone.
6
Power Switch
To switch on/off the router.
7
Power Receptor
Receptor for the Power Adaptor.
8
WPS Button
To enable WPS, press the WPS button for
longer than 5 sec.
To disable Screen Saver, press the WPS button
briefly.