Operation Manual

Information – for more information: www.bang-olufsen.com
Mains cord and plug
Power saving
Sockets on the connection panel
The supplied plug and mains cord are specially designed for the product. Do not change the plug and if the
mains cord is damaged, you must buy a new one from your Bang& Olufsen retailer.
If POWER SAVING is set to OFF in the STANDBY SETTINGS menu, the standby indictor remains red, when the TV
is switched off.
The connection panel on the back of the TV contains the sockets for connection to the BeoSystem and
connection to the mains supply.
Set up your television
This Guide contains information about the connection and setting-up of your TV
with a Bang& Olufsen BeoSystem. For general information on daily operation, see
the BeoSystem Guide enclosed with your TV. We expect your retailer to deliver,
install and set up your product.
Run cables
When the TV is mounted on the wall bracket, you
can push down the distance bracket to access the
connection panel. For more information on how
to mount the wall bracket, see ‘Mounting the wall
bracket’.
Connections
Make the connections while both the TV and your
BeoSystem are disconnected from the mains.
Connect the TV using the appropriate type of
cables. When all connections are made, connect
your whole system to the mains supply. Your TV
has an integrated centre speaker. To enhance the
sound experience, you can connect additional
speakers.
Overview
1 Standby indicator. When the TV is switched on
or off the standby indicator lights up briey. If
you use your BeoSystem, without picture on the
TV screen, the indicator light is green, indicating
that your BeoSystem is switched on.
2 IR blaster sending 3D signals.
3 IR-receiver for receiving the remote control signals.
4 Sensor arm for Automatic Colour Management.
For safety reasons, secure the cables with cable
strips. Place the cables behind the distance bracket.
1
2
2
3
4
POWER LINK
POWER LINK
HDMI IN
POWER LINK
IR OUT
DISPLAY 1
POWER LINK -CENTRE 1
IR IN
CONTROL
MONITOR
BEOSYSTEM
8