User's Manual

Corrections to the Guide page 65
For the American market only…
This equipment complies with Part 68 of
the Federal Communications
Commission (FCC) rules for the United
States.
A label is located on the underside of the
base unit containing either the FCC
registration number and Ringer
Equivalence Number (REN). You must
upon request, provide the following
information to your local telephone
company:
USOC Jack Type: RJ11
REN: 0.1B
Should you experience trouble with this
telephone equipment, please contact:
Bang & Olufsen America, Inc.
780 West Dundee Road
Arlington Heights
IL 60004 U.S.A.
Phone: [phone]
Main Fax: [phone]
The REN is used to determine the
quantity of devices which may be
connected to the telephone line.
Excessive RENs on the telephone line
may result in the devices not ringing in
response to an incoming call. In most,
but not all areas, the sum of RENs should
not exceed five (5.0). To be certain of the
number of devices that may be
connected to a line, as determined by
the total RENs, contact the local
telephone company.
If trouble is experienced with
BeoCom 1, for repair or warranty
information, please contact:
Bang & Olufsen America, Inc.
780 West Dundee Road
Arlington Heights
IL 60004 U.S.A.
Phone: [phone]
Main Fax: [phone]
If the equipment is causing harm to the
telephone network, the telephone
company may request that you
disconnect the equipment until the
problem is resolved.
This equipment cannot be used on
public coin phone service provided by
the telephone company. Connection to
party line service is subject to state
tariffs.
Your telephone company may
discontinue your service if your
equipment causes harm to the telephone
network. They will notify you in advance
of disconnection, if possible. During
notification, you will be informed of your
right to file a complaint to the FCC.
Occasionally, your telephone company
may make changes in its facilities,
equipment, operation, or procedures
that could affect the operation of your
equipment. If so, you will be given
advance notice of the change to give
you an opportunity to maintain
uninterrupted service.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's
authority to operate the equipment.
This equipment complies with FCC
radiation exposure limits set forth for an
uncontrolled environment. This device
complies with FCC SAR limit of 1.6
mW/g. The maximum SAR value
measured was 0.082mW/g. This device
must not be co-located or operating in
conjunction with any other antenna or
transmitter.
NOTE: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or
television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to try
to correct the interference by one or
more of the following measures:
– Reorient or relocate the receiving
antenna.
– Increase the separation between
the equipment and receiver.
– Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced
radio/TV technician for help.
3507360 0309 Printed in Denmark by Bogtrykkergården a-s, Struer