User Guide User guide

Use BeoLab 5 with a non-Bang&
Olufsen system
The loudspeakers must be connected as explained
on page 10, and the Option number set to 1 or 4,
as explained on page 11.
Operate your non-Bang & Olufsen system as you
normally would. However, you will have to use a
Beo4 remote control (optional accessory) to do the
following:
– Switch the loudspeakers on and off;
– Turn the volume level up or down;
– Adjust the left–right sound balance (when you
switch on the loudspeakers, the balance is
always neutral);
– Store and reset sound levels;
– Use the PIN code system;
– Change Option setting and LINE input level.
Although BASS, TREBLE, LOUDNSS are available in
the Beo4 display you cannot adjust these levels
usingBeo4. We recommend that you keep any
tonecontrol settings neutral.
For specic information about the Beo4 remote
control, please refer to its own guide
.
If BeoLab 5 is programmed to
Option 1
To switch BeoLab 5 on/off…
> Press RADIO to switch on.
> Press • to switch off.
To turn the volume level up/down...
> Press to turn the volume up.
> Press
to turn the volume down.
To reset the sound level...
> Press LIST, until RESET* is shown in the Beo4
display
> Press the centre button to reset sound level.
To shift the left–right sound balance...
> Press to shift the sound towards the left, and
press
to shift the sound towards the right.
To store a new start up sound level…
> Press until you reach your preferred start up
sound level.
> Press LIST until A.SETUP* is shown in the Beo4
display.
> Press the centre button to accept.
> Press LIST until S.STORE is shown in the Beo4
display.
> Press the centre button to store the setting.
If BeoLab 5 is programmed to
Option 4
To switch BeoLab 5 on/off…
> Press LIST until LINK* is shown in the Beo4
display, and then RADIO to switch on.
> Press • to switch off.
To turn the volume level up/down...
> Press to turn the volume up.
> Press
to turn the volume down.
To reset the sound level...
> Press LIST until RESET* is shown in the Beo4
display.
> Press the centre button to reset sound level.
To shift the left–right sound balance...
> Press to shift the sound towards the left
press
to shift the sound towards the right.
To store a new start up sound level…
> Press until you reach your preferred start up
sound level.
> Press LIST until A.SETUP* is shown in the Beo4
display.
> Press the centre button to accept.
> Press LIST until S.STORE is shown in the Beo4
display.
> Press the centre button to store the setting.
*Must be added to the Beo4 LIST-function. See the
Beo4 online guide at www.bang-olufsen.com/guides
.
Option 1
Option 4
5