BeoLink Active Setting-up Guide
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: To reduce the risk of electric shock, do not remove cover (or back). No User-serviceable parts inside. Refer servicing to qualified s ervice personnel. WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. Do not expose this equipment to dripping or splashing and ensure that no objects filled with liquids, such as vases, are placed on the equipment.
Read these instructions. Keep these instructions. Heed all warnings. Use only with the cart, stand, tripod, bracket, or table Follow all instructions. specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when Do not use this apparatus near water. moving the cart/apparatus combination to avoid injury from tip-over. Clean only with dry cloth. Unplug this apparatus during lightning storms or Do not block any ventilation openings.
B E F O R E Setting-up guide This guide describes how to in stall your BeoLink Active kit in a BeoLink distribution system. If you have never carried out cable installation before, we suggest you leave it to your Bang & Olufsen retailer. Likewise, we recommend that you follow the instructions in this guide carefully. The Guide which is also supplied with the BeoLink Active kit describes how to operate your system once it has been installed.
P lacement A A To fasten the BeoLink Active receiver to the wall: 1 Using the wall bracket as a template, mark and drill the holes in the wall. 2 Using the two screws and wall plugs supplied (A), fasten the wall bracket. 3 When you have mounted the receiver cable (see page 5) hang the receiver on the wall bracket and then secure it with the tiny screw (B). 4 Fasten the cable to the wall and run it to the BeoLink Active box.
C onnections Cables should always be handled with great care. When running the cables, avoid bending them too sharply and be careful not to twist them. Avoid subjecting the cables to pressure or impact. Using the cable supplied, connect the BeoLink Active receiver as follows: 1 Detach the rear cover of the BeoLink Active receiver (unscrew the two screws (C) and loosen the two screws (D), then lift off the cover).
> Connections Master Link connection to the main system Main System Junction box PC* Connect one speaker to the socket marked Power Link and then loop the signals through to the other speaker as described in the User’s guide for your speakers. Link System BeoLink Active box In the link room: Using a Master Link cable, connect the multi-pin plug to the socket marked MASTER LINK on the BeoLink Active box, and run the cable to the junction box.
R eady for use … When you have made all the connections as described in the previous chapter you may start using the system. However, in order for your setup to function properly, you may need to preprogram it. Your BeoLink Active can be preprogrammed for the following setup situations (Options): Option 0: To be used if you want to disable remote control operation of the BeoLink Active (to re-enable remote control, select one of the other options).
Waste Electrical and Electronic Equipment (WEEE) – Environmental protection Electrical and electronic equipment, parts and batteries marked with this symbol must not be disposed of with normal household wastage; all electrical and electronic equipment, parts and batteries must be collected and disposed of separately.
For the US-market only! NOTE: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter ference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not in stalled and used in accordance with the instruc tions, may cause harmful interference to radio communications.
3500926 1104