User`s guide

7
R E A D Y F O R U S E …
When you have made all the connections as described in
the previous chapter you may start using the system.
However, in order for your setup to function properly, you
may need to preprogram it.
Your BeoLink Active can be preprogrammed for the fol
-
lowing setup situations (Options):
Option 0: To be used if you want to disable remote con
-
trol operation of the BeoLink Active (to re-enable re-
mote control, select one of the other options).
Option 4: To be used if you install the BeoLink Active
in the same room as your main system (e.g. in a large
L-shaped living room with two separate listening posi
-
tions).
Option 5: To be used if you install a TV set in the same
room as your BeoLink Active.
Option 6: To be used for a setup with the main system
in one room and the BeoLink Active in another, as de
-
scribed in this guide, and in a setup with BeoLink PC
Office (this is the factory setting).
NOTE! To ensure correct function
of your setup, it is essential that
you connect both the main system
and the speakers to the mains
– before connecting the BeoLink
Active box to the mains!
Using a Beolink 1000:
– Press LINK, the appropriate
number (0, 4, 5 or 6), and
then STORE.
Using a Beo4:
– Hold the • button while
pressing LIST. When the Beo4
display reads OPTION?, press
GO.
– Press LIST twice to display
L.OPT and then key in the
appropriate number (0, 4, 5
or 6).
The preprogramming is done with a Bang & Olufsen
remote control, and must be carried out with both the
main and link system switched to stand-by!