User Manual

Table Of Contents

4.4 Preparation before measurement

4.4 .1 Tap the power source button to power on. If the battery

voltage is low (about 2.8V), the monitor will display " "

symbol, then should charge. Press the power button again

to turn it off.

4.4 .2 When the instrument is not measured, the instrument enters

the automatic scanning state and the instrument displays

4. 5 Non-contact Voltage Detection (NCV)

4.5.1Touch the NCV key to enable the NCV function, and the

instrument displays NCV

4.5.2The NCV sensor is placed close to the measured wire, and the

instrument can detect whether the measured wire is gt. 90V

ac voltage. When the meter detects the ac power, the meter

buzzer alarms and the LCD analog bar displays the induction

intensity.

Note:

1) Voltage may still exist even if there is no alarm indication. Do not

rely on contactless voltage detectors To see if there's a voltage

on the wire. Probe operation may depend on socket design,

insulation thickness Different types of factors such as the impact.

2 ) In NCV mode, the meter does not measure voltage, resistance,

and current at the same tim

Operational guidelines