User Manual

Table Of Contents

4.6 Ac-dc current measurement

4.6. 1Insert the stylus into the 10A current input hole, and the

current input terminal is inserted into the stylus automatic

identification function on on Automatically enters the default

DC current gear of the current gear system. Remove the 10A

current input hole and the stylus automatically jumps out of the

current gear and enters the AUTO measurement mode

Note:

When the meter is in diode

gear, the pen is inserted into the

10A input hole and the meter will

not enter current gear.

4.6. 2Connect the pen into the

measured signal, when the

measured signal > The meter

will display the current measured

value at 20mA. When measured

ac signal > At 3000rnA, the

instrument pair displays the AC

current frequency.

4.7 Dc voltage measurement

Insert the black stylus into the COM jack and the red stylus into

the V jack. Connect the markers together The voltage source or

load ends are measured and read on the LCD.

AUTO automatic measurement mode:

when the measured signal > At 0.5V, the meter will display

the current measured DC voltage value. When the signal being

measured. At 0.5V, the meter will default to the resistance value

and display the internal resistance value of the measured signal.

Touch the " " key to switch to the DC mV voltage level.

Connect the pen to both ends of the voltage source or load for

measurement, reading on the LCD.

Operational guidelines