User Manual

Table Of Contents

4.9 Resistance measurement

When measuring the impedance on the line, make sure

that the circuit is disconnected and the capacitor on the

circuit discharges completely.

4.9.1 Insert the black stylus into the COM jack and the red stylus

into the " " jack.

4.9.2 AUTO AUTO range tap. At this time, the meter is in automatic

scanning state.

4.9. 3 Connect the pen to the measured resistance or both ends of

the line for measurement, reading in the LCD display.

Note:

1 ) When the input is open, the LCD will display the "OL"

overrange status.

2) If the resistance being measured is higher than 10MΩ,

the meter may take several seconds to stabilize the

reading, which is normal for high resistance readings.

Operational guidelines

warning