Owners manual

7

INSTALLATION PROCEDURE

     DO NOT WORK UNDER
ANY VEHICLE SUPPORTED ONLY BY A JACK!
     
parallel to and outside of the frame rail under
  


will be mounted to
       
See Figure 1DO NOT mount the TransCommand
to the frame rail, as it may become hot.
  
 
  



NOTE: On some vehicles it may be necessary to mount
the TransCommand
to the body next to the frame
rail. In this case, mark drilling locations using the
TransCommand
bracket as a template and drill two
mounting holes using a
3
16
” drill.
 
4
–28 x
5
8
   
4
–28 nylock
   
to the body
Figure 1.
NOTE: On vehicles where the TransCommand will mount to
the body next to the frame rail, mount the TransCommand
using two
1
4
dia. x
5
8
” sheet metal screws provided.
     

 See Figure 2.  



NOTE: On vehicles equipped with an E40D, this plug is
located behind the small metal shield. Using an 8mm
wrench, unbolt this shield to reveal the plug. On vehicles
equipped with a 4R100, it may be necessary to unbolt
the exhaust heat shielding and slide it out of the way to
access the plug. (There is no small metal shield.)
 
   
from between the two rows of pin sockets in the



screwdriver tip between the connector shell and the
See Figure 3.
 Figure 3 


IMPORTANT: Make a diagram showing the wire
colors of pins 1, 11, and 12. Write them down on
Figure 3. These colors vary with the vehicle year
and must be hooked to the proper connections in
later steps.


  

the wire and pin socket from the back side of the


 Figures 3 and 4    
female socket/wire ends from the Banks

harness into the factory transmission










FIGURE 2