Owners manual

9

NOTE: Pin No. 4 hole is not used.
Insert the thin end of the supplied red plastic

Inspect the new connector assembly by double
       
wires from the rear of the connector to be sure they

        

    

NOTE: If the connector doesn’t “snap” into position
easily it is possible that the rubber seal that is supposed
to be around the Ford wire loom connector has come
off the plug and is down the transmission socket. If this
has happened, remove the seal with a small pick and
slide it over the red retainer and try again.

 
™
   
transmission crossmember and under the frame
as shown in Figure 1   
™
       

™

       
      
     
See Figure 2.
      
      

™
     

NOTE: The following symptoms would indicate a
wiring error. If the “Check Engine” light (or Over Drive
indicator light) flashes, or the transmission appears
to have third gear only, or very harsh shifting occurs,
check the following. Be sure the wiring is correct,
the pins are all fully seated in the connectors and the
connectors are fully mated.







FIGURE 5