User guide

96458 v.1.0 9
11. From the stock air box, remove
the stock air filter Minder. Make sure
to remove the stock air filter Minder’s
rubber grommet as well. See Figure 5.
12. Install the air filter Minder’s
rubber grommet into the Banks Ram-
Air filter housing cover. Once the
rubber grommet is installed flush into
the Banks Ram-Air cover, then the
filter Minder can be inserted into the
rubber grommet. Make sure the air
filter Minder is installed flush to rubber
grommet.
13. Locate the Banks Ram-Air filter
element and the Banks air filter hose
clamp. Loosely fit the filter clamp to
the air filter element.
NOTE: See Figure 6 to reference the
correct alignment locater groove to the
Banks Ram-Air filter.
14. After verifying the alignment
between the Banks Ram-Air filter
and the Banks Ram-Air cover, press
fit the two pieces together until an
audible snap is heard. This process will
ensure that a correct seal has been
established.
15. Tighten the Banks Ram-Air filter
hose clamp to the Banks Ram-Air filter
cover.
16. Place the Banks Ram-Air filter
cover onto the Banks Ram-Air housing.
Align and loosely fit the cover onto the
housing.
17. Install, but do not tighten, the
Banks bellows hose and hose clamp
onto the Banks Ram-Air housing cover.
Figure 5- Remove Stock Air Filter Minder & Air Filter Minder Gasket