Owner's manual

96538 v.3.0 5
6. Install the Exhaust clamp on the inlet
of Banks intermediate pipe. Install Banks
intermediate pipe to the previously cut
pipe outlet. Be sure the intermediate
pipe jog is orientated as shown in
Figure 4. Lightly tighten the Exhaust
clamp on the intermediate pipe inlet.
NOTE: All clamps should be positioned
at the beginning of the slots (on the
1
⁄2
circle punch).
7. Install the front hanger clamp onto
the intermediate pipe outlet. Insert the
hanger pin into the vehicles rubber
hanger (see Figure 4).
8. Install the Monster Muffler inlet
(Note the inlet labeling of the muffler)
onto the intermediate pipe outlet.
Orient the Monster logo such that is
visible from the passenger side and
parallel with the frame rail. Align the
clamp onto the muffler inlet (see
Figure 4).
NOTE: Once the pipe / muffler has
been completely engaged in the slip
joint, mark the pipe with a scribe or
tape for reference when tightening the
clamps later in the installation. Mark
each slip joint in this fashion.
9. Install the rear muffler hanger
clamp onto the Monster Muffler outlet.
Insert the hanger pin into the vehicles
rubber hanger (see Figure 4).
NOTE: For some models, only one
factory rubber hanger is provided for
supporting the rear muffler outlet.
10. From the vehicle rear, route the
tailpipe over the rear end. Install the
tailpipe into the Banks Muffler outlet.
Start the tailpipe hanger pin into the
corresponding vehicle rubber hanger.
Lightly tighten the rear muffler hanger
clamp to secure the tailpipe
11. Adjust the tip about
1
⁄2” under the
body panel, such that the tip position
is aesthetically pleasing.
Figure 3 4.8L Model Factory Intermediate Pipe