User Manual

ManualsBrandsBanks Power ManualsToolsDynaFact Dash Pod '03-05 Dodge 5.9L Cummins Truck

03/28/06 PN 96516 v.1.0

Banks DynaFact

Dash Pod

2003 to 2005 Dodge 5.9L Cummins

(24 valve) ISB Pickup Trucks

THIS MANUAL IS FOR USE WITH KIT 63319

Gale Banks Engineering

546 Duggan Avenue • Azusa, CA 91702

(626) 969-9600 • Fax (626) 334-1743

roduct Information & Sales

: (800) 438-7693

Customer Support:

(888) 839-5600

Installation Support: (888) 839-2700

bankspower.com

Owner’sManual

with Installation Instructions

Summary of content (8 pages)

PAGE 1
with Installation Instructions Owner’sManual Banks DynaFact Dash Pod ® 2003 to 2005 Dodge 5.9L Cummins (24 valve) ISB Pickup Trucks THIS MANUAL IS FOR USE WITH KIT 63319 Gale Banks Engineering 546 Duggan Avenue • Azusa, CA 91702 (626) 969-9600 • Fax (626) 334 -1743 Product Information & Sales: (800) 438-7693 Customer Support: (888) 839-5600 Installation Support: (888) 839-2700 bankspower.com ©2006 Gale Banks Engineering 03/28/06 PN 96516 v.1.
PAGE 2
General Installation Practices 1. For ease of installation of your Banks DynaFact® Dash Pod familiarize yourself with the procedures by reading the entire manual before starting work. This instruction manual contains 8 pages of text, and illustration. 2. Route and tie wires and hoses a minimum of 6 inches away from heat source, moving parts and sharp edges. Clearance of 8 inches or more is recommended where possible. 2 96516 v.1.
PAGE 3
Banks DynaFact® Dash Pod Installation Note: Due to normal manufacturing processes you may have “flashing” (small fibers of plastic) around the pod holes. Once the gauge(s) are installed in the pod you will not be able to see the flashing. This mount is designed to hold gauges with a press or friction fit. To allow you flexibility in the positioning of your gauges, all of the holes are cut to the same size. Oil temperature gauges and boost gauges should fit into this mount with no modification.
PAGE 4
Figure 2 the screws. Remove the storage pocket from the dash panel. See Figure 3. 4.Install the gauges into the dash pod. Figure 3 4 96516 v.1.0 5.Fit the dash pod with the installed gauges into the dash panel. 6.Locate the two (2) U-brackets in the dash pod kit.
PAGE 5
bracket to both outer gauges and fasten with spin nuts. See Figure 4. 7.Complete the wiring of the gauges per the instructions supplied with the gauges. 8.Refit the dash panel by carefully snapping it back into place. Be careful not to pinch any wires when installing the dash panel. 9.Your dash pod is now installed and is ready for use. See Figure 5.
PAGE 6
Figure 5 6 96516 v.1.
PAGE 7
Notes 96516 v.1.
PAGE 8
Gale Banks Engineering 546 Duggan Avenue • Azusa, CA 91702 (626) 969-9600 • Fax (626) 334 -1743 Product Information & Sales: (800) 438-7693 Customer Support: (888) 839-5600 Installation Support: (888) 839-2700 bankspower.