assembly (Electronic) Instruction Manual

Dear Customer,
If you have any questions
concerning the installation of
your Banks DynaFact Boost and
Pyrometer Gauge, please call
our Technical Service Hotline at
[phone] between 7:00 am
and 5:00 pm (PT). If you have
any questions relating to
shipping or billing, please
contact our Customer Service
Department at [phone].
Thank you.
1. For ease of installation of your
Banks DynaFact gauge mount,
familiarize yourself with the
procedures by reading the entire
manual before starting work.
This instruction manual contains
4 pages of text, and illustration.
2. Route and tie wires a minimum of
6 inches away from moving parts and
sharp edges. Clearance of 8 inches or
more is recommended where possible.
Tools Required:
• Philips head screwdriver
•
3
⁄8” open-end wrench
• Flat head screwdriver or
1
⁄4” nut runner
• Drill motor
•
3
⁄16” drill bit
•
1
⁄8” drill bit
• Wire stripper/crimping tool
General Installation Practices
2 96790 v.3.0