Manual

12 96831 v.6.0
Figure 6 Banks Bridge Module
7. Locate Banks iQ Bridge Module and
connect the RJ12 connector into the
Bridge Module. See Figure 6.
8. Route the Banks iQ USB interface
cable on the Banks iQ Bridge Module to
reach the Banks iQ and connect it to the
left receptacle on the iQ.
NOTE: You may need to loosen or
remove dash panel or covers to install
the interface cable between dash crevice
or behind dash panels.
WARNING: THE CHARGING CABLE
CONNECTED TO THE BANKS iQ IS
DESIGNED TO SUPPLY A CONSTANT
LOW-VOLTAGE POWER SOURCE
(+5VDC) TO THE BANKS iQ AND IS
“LIVE” AS LONG AS THE SYSTEM’S
OBD II INTERFACE CABLE OR BANKS
WIRING HARNESS IS COMPLETELY
INSTALLED AND THE USB CABLE
CONNECTOR IS PLUGGED INTO
BANKS iQ. ALTHOUGH THIS
CHARGING CABLE CIRCUITRY IS
FUSE-PROTECTED, THE USER IS
EXPECTED TO TAKE APPROPRIATE
MEASURES TO PREVENT SMALL
CHILDREN AND/OR PETS FROM
CONTACT WITH ANY PART OF THIS
SYSTEM.
9. Secure Banks iQ Bridge Module
under the dash to any dash frame
support using the supplied cable ties.
Use the cable tie support loops on the
side of the Bridge Module to securely
fasten it under the dash.
10. Route all wiring away from any
pedals or other moving components.
Using the cable ties supplied, secure
the wiring under the dash.
-END, SECTION 3-