Manual

24 96831 v.6.0
Receive Diagnostics Update
Notices
Banks iQ is constantly evolving and new
diagnostics updates may be available.
We invite you to register at www.
bankspower.com/banksiq to receive
important emails regarding updates and
upgrades for your Banks iQ device.
Vehicle Diagnostics
Diagnostic Trouble Codes (DTC) are error
codes that are generated when there is a
problem with your vehicle. If your vehicle
dashboard displays a check engine
light, DTC(s) will be available to assist in
diagnosing the problem. You can use the
Banks iQ to run a vehicle system check
and display these DTC(s). A code will
be given along with a brief description
of the problem, a full description of the
code will display below the code list
when the code is highlighted. You may
call your vehicle dealer or reference your
vehicle service manual for description
and possible corrective action to fix the
problem. Once the problem has been
repaired you can clear the code to turn
the check engine light off.
NOTE: Keep a written record of the DTC
code(s) that display on your Banks iQ for
future reference before clearing them.
Check for OBD II DTC(s)
If any vehicle DTC(s) are present,
troubleshoot/repair the cause. Once the
cause is properly remedied, touch ‘Clear
Codes’ and then ‘Check for Codes’ again
to verify the problem is fixed (the OBD
II code should not re-appear). You may
need to complete a driving cycle for the
code to not re-appear.
1. In the Environment Select menu
press on the ‘Diagnostics’ button.
2. In the Diagnostics menu press on
the ‘Vehicle Diagnostics’ button. See
Figure 22.
3. With the ignition in the on/run
position or with the engine running,
press on the ‘Check for Codes’ button.
See Figure 23.
NOTE: On certain vehicles, the ignition
key must be in the On/Run position,
but the engine must NOT be running.
If the engine is running, Banks iQ will
display a pop-up message instructing
you to confirm that the ignition key is
in the ON position.
NOTE: The Banks iQ will check for
vehicle diagnostic codes and display
either the code with a brief description
or the message “No codes found”. For
a full description of the code, highlight
the code and the description will
appear below the code list box.
Section 10
DIAGNOSTICS ENVIRONMENT
Figure 22 Diagnostics Menu