Manual

38 96831 v.6.0
1. Select the ‘Wrench’ icon to go to
the ‘Adjustments’ menu. Press the
‘On Screen Alerts’ button.
2. Scroll Up or Down through the
optional Alert Parameters available on
the left hand side of the screen. See
Figure 39.
3. Highlight the desired parameter on
the left side of the screen.
4. Press the plus (+) or minus (-)
symbols to increase or decrease the
selected parameter Alert Set Point.
The display shows the adjusted value.
NOTE: the limit for each parameter
Alert Set Point is displayed right above
the adjusted value Set Point.
5. To set the volume sound level for
the alerts, Press the plus (+) or minus
(-) symbol below the ‘Reset’ button to
increase or decrease the sound level.
Three (3) volume levels plus a silent
mode are available.
6. Repeat steps 2 through 5 to adjust
all the desired parameters.
7. Once all parameter have been
adjusted and to save changes, press
the iQ icon to return to the Environment
screen or the ‘Return’ icon to return to
the ‘Adjustments’ Menu.
NOTE: In the event an alert set point
is reached an audible alarm will sound
and the Status Indicator will display an
icon relative to the associated alert.
See Figure 40. The alarm will turn
off once the associated parameter is
below its alert set-point. The Status
Indicator will then return to ‘OK’.
8. You can return Banks iQ to its
default alert settings at any time by
pressing the ‘Reset To Default’ button.
-END, SECTION 19-
Section 19
ON SCREEN ALERTS
Figure 40 Alert indicator icons
Figure 39 Alert Screen