Manual

40 96831 v.6.0
Banks Bridge
The Banks Bridge Module transports
information back and forth between your
vehicle and Banks iQ. Note that there are
two green lights on this Module. With the
ignition off and the Banks Bridge viewed
with the “banks” logo reading properly,
the right hand light will pulse on and off.
With the engine running and Banks iQ
connected, both lights will switch back
and forth to tell you that Banks iQ is
communicating with your vehicle. Should
Banks iQ become disconnected, the left
light will pulse on and off to tell you that
communication has been interrupted.
Loss of communication between
Banks iQ and vehicle.
A magnifying glass icon will appear in
the upper right-hand corner of Banks iQ
display. See Figure 43
1. Make sure the vehicle ignition key is
in the ON position.
2. Make sure the Banks iQ is properly
connected to vehicle as described in
Section 3.
3. Check the connection at the OBD II
diagnostic port (under the driver’s side
dash area). Check for any damage to the
ODB II connector “hood”, such as if it has
become dislodged from the connector
housing.
4. Check the RJ12 connection at the
Banks Bridge.
5. Check the USB connection at the
Banks iQ.
Section 22
TROUBLESHOOTING
Figure 43
Searching Icon
Figure 42