User Manual

16 96584 v.5.0
control panel should push easily in and

look for kinked or pinched wiring.)
14.
located in the cabin compartment.
Locate mini-fuse #22 and remove.
Install the mini-auto blade fuse tap
onto the removed mini fuse as shown
in Figure 12. Re-install the mini fuse
with the attached blade tap into
location #22 as shown in Figure 13.
15. Locate the RED single terminal
connector on the Banks harness and
connect it to the mini-fuse blade tap
location #22. Replace the fuse cover
and make sure not to pinch the RED
single terminal wire.
NOTE: Make sure the inline fuse holder
is routed outside the factory fuse box.
16. Locate the BLACK ground
wire with the ring terminal on the
Banks Bullet wire harness. Install

terminals and re-install the screw. See
Figure 14.
17. Route the 6-pin connector from


and the two-pin connector from the
EGT thermocouple leadwire (if so
equipped) to the back of the Banks
Bullet module and plug them in.
Figure 11
Figure 12: Fuse tap