User Manual

96584 v.5.0 21
ALWAYS CAREFULLY MONITOR
YOUR EGT WHEN RUNNING
STACKED PERFORMANCE
MODULES.
Setting Default Display Options:
To set the desired default display
parameter from the normal display
MENU’ button until
‘DISP
‘SELECT’ button.
The currently selected engine parameter
is displayed – to continue operating with
this parameter displayed by default on
SELECT’
button – a ‘SAVED’ message will be
displayed and the module will return
to the normal display mode. To cycle
through the available parameter display
MENU’ button. ‘EGT’

from the thermocouple (if installed);
‘BST’ will display boost (manifold)
pressure; ‘FUEL’ will display the
amount of fuel entering the engine as
a percentage of the stock fuel amount.
’VER’ will display tuner part number and
current firmware/calibration version.
Press the ‘SELECT’ button to set the
currently displayed engine parameter
as the default display parameter – the

display a ‘SAVED
to the normal display mode where the
parameter you have just selected will
now be displayed on the module. If
no buttons are pressed within five (5)

standard display mode without saving
any changes.
Setting the Boost Level
Set Point:
To set the boost level at which the
Bullet module will trigger a visual alarm

press the ‘MENU’ button while in the
normal display mode until ‘B SP’ is
SELECT’
button.
The current Boost Level Set Point will

is 50 PSI). Press the ‘SELECT’ button
to continue operating with this Boost
Level Set Point and return to normal
operating mode (the module will display
a ‘SAVED’ message confirming your
MENU’ button
to cycle through all available Boost Level

in 1 PSI increments.
Press the ‘SELECT’ button when
your desired Boost Level Set Point is

SAVED’

display mode. If no buttons are pressed

return to the standard display mode
without saving any changes.
NOTE: In the normal display mode
‘T SP’ (Transmission Temperature
Set Point) is a non-functioning
setting for this model vehicle.
This menu will still be accessible
and editable, but the settings it
contains will not have any affect
on the Bullet diesel tuner. Please
disregard this setting.
--