User Manual
8 96584 v.5.0
1.
yourself with the installation procedure
by reading all of the instructions.
2.
general guidance. Refer to each step
and section diagram in this manual for
proper instruction.
3.
left side of the vehicle refers to the
passenger side.
4. Disconnect the negative (ground)
there are two) before beginning work.
5. Route and tie wires and hoses a
edges. Clearance of 8” or more is
recommended where possible.
6.
it on properly weight-rated safety
Follow the manufacturer’s safety
precautions. Take care to balance the
vehicle to prevent it from slipping or
front wheels are centered squarely on
the topsides. When raising the front
rear wheels. When raising the back of
level ground and the front wheels are
blocked securely.
CAUTION: Do not use floor jacks
to support the vehicle while
working under it. Do not raise
the vehicle onto concrete blocks,
masonry or any other item not
intended specifically for this use.
7.
area clean. Do not allow anything to
lubrication system components while
objects will cause immediate engine
damage upon start-up.
8. Save this Owner’s Manual as a
reference for system maintenance and
service.
9. Banks also recommends the
following airflow improvements (see
Recommended Airflow Improvements
page 9) to maintain safe engine
operating conditions and provide
increased power gains.
Tools Required:
wrenches
⁄16” Drill bit
7
⁄16” Drill bit
1
⁄4” NPT tap and tap handle
Highly recommended
tools and supplies:
spray
General Installation Practices