Product Description

BANLAW PRODUCT DATA SHEET PRODUCT NAME

Doc ID: PRH-FMG-76 Version: 0.38

Page 3 of 15

Please ensure you have the latest version of this document.

1.1 Operation

The Wireless Swivel operates continuously and when not in use enters a sleep mode to conserve battery

power. An internal accelerometer senses movement and wakes the swivel. The status of the Wireless Swivel

can be determined from the two status LEDs visible through the LED status window, see Figure 2 below.

Figure 2 Location of LED status window and magnet reset zone.

The table below shows status LEDs indication

Red LED Green LED Status

Fast red and green flashing pattern After the control board boots up, the controller searches

for wireless firmware update for approximatly 5 seconds.

If the controller detects a firmware update, wireless

firmware download starts and both red and green LEDs

flash. When firmware download is comple the controller is

reset to load the new firmware.

Flashing rapidly for 1 sec Flashing rapidly for 1 sec Application firmware has started.

Continuously flashing at

1.5 / sec

Wireless swivel control board is waiting for iButton

contact.

Flashing quickly twice iButton has disconnected. The nozzle is disconneted from

receiver.

Continuously flashing 1.5

times / sec

Wireless swivel control board is sending iButton data to a

gateway device. The nozzle is connected to a receiver

Flashing quickly 2 times iButton has been connected.

OFF OFF Wireless swivel control board is sleeping (shake the

Wireless Swivel to wake up)

Reseting the Wireless Swivel. The Wireless Swivel is a potted assembly and has no mechanical reset switch.

However the control board has a magnetic reset switch that can be envoked if a reset is required. To reset the

control board place a magnet over the reset zone (shown in

Magnet

Reset Zone

Status

Window