Cut Sheet

Sensor Scan Time
For all models: 55 microseconds per beam plus processing me. The processing
me is dependent on the scan analysis and the number of acve outputs. This
ming assumes a straight scan, connuous, and TBB mode.
MAC-1, MACN-1 & MACP-1: 1 millisecond processing me.
MACV-1 & MACI-1: 1.5 milliseconds processing me.
MAC16N-1 & MAC16P-1: 2.3 to 7 milliseconds processing me.
Construcon
Polycarbonate
Environmental Rang
NEMA 1 (IP20)
Operang Condions
−20 °C to +70 °C (−4 °F to +158 °F)
95% maximum relave humidity (non-condensing)
Cercaons
Required Overcurrent
Protecon
WARNING: Electrical connecons must be made by
qualied personnel in accordance with local and
naonal electrical codes and regulaons.
Overcurrent protecon is required to be provided by end product applicaon
per the supplied table.
Overcurrent
protecon may be provided with external fusing or via Current
Liming, Class 2 Power Supply.
Supply wiring leads < 24 AWG shall not be spliced.
For addional product support, go to www.bannerengineering.com.
Supply Wiring (AWG) Required Overcurrent Protecon (Amps)
20 5.0
22 3.0
24 2.0
26 1.0
28 0.8
30 0.5
3.4 Dimensions for the Controller
75.0 mm
(2.95")
60.8 mm
(2.40")
7.1 mm
(0.28")
Din mounting tab
(supplied)
Slot for screws (2)
M3.5 x 0.6 mm (2)
35.0 mm
(1.38")
Din mounting slot
100.0 mm
3.94"
85.3 mm
3.36"
7.4 mm
(0.29")
110.0 mm
(4.33")
Combo Head (Phillips/Slotted Screws
M3.5 x 0.6 mm x 14 mm (2 ) (#6 x 0.5" equivalent) (supplied)
M3.5 Washers (2) (#6 equivalent) (supplied)
M3.5 mm x 0.6 mm Nuts (2) (#6 equivalent) (supplied)
Recommended torque is
16-20 in -lbs on mounting screws
A-GAGE
®
MINI-ARRAY
®
Measuring Light Screen System
www.bannerengineering.com - Tel: [phone]