Cut Sheet

Set Switchpoint
Method Action Result
Push Button
a. Align sensor to the reflector.
b. Press and hold "+" > 2 seconds.
Green Power LED: OFF
Amber Output LED: ON
11 33 44 55 66 77 88 22
LOLO
DODO
+
GAIN
—
Switchpoint Accepted
Bar graph: #7 and 8 flash for 2 sec
Amber Power LED: OFF
Green Power LED: ON
Bar graph: Appropriate LED ON
• Sensor returns to RUN mode with new
settings
• Use Manual Adjust to increase or decrease
sensor sensitivity
11 33 44 55 66 77 88 22
LOLO
DODO
+
—
GAIN
Switchpoint Not Accepted
Bar graph: #1, 4, 5, and 8 flash for 2 sec
Green Power LED: ON
• Sensor returns to RUN mode without
saving (maintains previous settings)
11 33 44 55 66 77 88 22
LOLO
DODO
+
—
GAIN
Remote Input
3
a. Align sensor to the reflector.
b. Single-pulse remote line.
T
SETUP Mode
SETUP mode is accomplished via the sensor’s two push buttons. It
is used to change sensor output response for:
• Light or Dark Operate
• 30-millisecond pulse stretcher (OFF-delay), if required.
The status LEDs, active only during SETUP mode, indicate the
output response configuration when the sensor will be in RUN
mode.
11
33
44
5
6
7
8
22
LO
DO
+
GAIN
—
SETUP
status
indicators
Figure 7. SETUP Mode
1. Access SETUP Mode.
3
0.04 seconds ≤ T ≤ 0.8 seconds
WORLD-BEAM QS30 LLP and LLPC
6 www.bannerengineering.com - Tel: [phone] P/N 112355 Rev. E