User's Manual

SureCross™ DX80 Quick Start Guide
P/N 128185 Rev B 5
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: [phone]
When power is applied, the DX80 immediately enters *RUN mode. *RUN mode is the normal operating mode for all devices on the
wireless network.
From the *RUN Menu (or any menu), single-click button 1 to advance through the top-level menus.
To return to the top level menus and autoscrolling mode, double-click button 2 twice.*** To enter manual scrolling mode, double-click
button 2 at the top level menu. The device autoscrolls through the *RUN, *DINFO, and *FCTRY menus if paused on those menu
headings. If the device is paused on the *DVCFG or *DERR menu options, the display does not autoscroll.
*
DINFO
*
RUN
*
FCTRY
*
DVCFG
*
DERR
AUTO
DISPLAY
LOOP
AUTO
DISPLAY
LOOP
AUTO
DISPLAY
LOOP
(DEV)
NOD XX
(NAME)
NODE XX
KIT
XXXXX
(NID)
XX
(DEV)
NOD XX
(RADIO
MICRO)
V 00.0 A
(DX80
S/N)
0x0000(2)
(LCD
MICRO)
0x0000(2)
(PROD
DATE)
(00-00)
Single-click
Button 2
NEW XX
Single-click
Button 2
Single-click
Button 2
SAVES NEW
VALUES
(NID)
Network ID
Single-click
Button 2
Double-click Btn 2 Double-click Btn 2
NEW XX
Single-click
Button 2
Single-click
Button 2
SAVES NEW
VALUES
(NADR)
Node Address
NOD XX
**
EC XX IGNORE
*
ERROR
Single-click Button 1
** LCD will display ‘NO ERR’ if no error is detected.
Single-click
Button 2
Single-click
Button 2
New Error
Detected
Single-click Button 2
OFF
Press and hold Button 1 from any top level menu to power down the Node.
Press and hold Button 1 from power down mode to enter RUN mode.
ADJUST LEFT
ROTARY SWITCH
TO SET
NETWORK ID
ADJUST RIGHT
ROTARY SWITCH
TO SET
NODE ADDRESS
Single-click
Button 1
(DEV)
I/O XX
NOD XX
NID XX
ON/OFF
Single-click
Button 1
Single-click
Button 1
Single-click
Button 1
(DX80
MODEL)
0x0000(2)
Navigating the menu:
* indicates a top level menu option
( ) indicates a sub-menu item
No characters indicate the value of the previous item
Node LCD Timeout: After 15 minutes of inactivity, the LCD screen stops displaying information. Press any button to refresh the display if
the Node has entered this energy-saving mode.
SureCross™ DX80 Node Setup Menu
** **
** The Network ID (NID) and Node Address
(NADR) can be set at any time from the
rotary switches. The left rotary switch sets
the Network ID and the right rotary switch
sets the Node Address.
*** At any point in the menu system,
double-clicking Button 2 twice returns to
the top level menu.