Instruction Manual
Table Of Contents
- Contents
- 1 The Sure Cross® Wireless Network
- 2 Features
- 3 Setting Up Your Wireless Network
- 3.1 Mixing Performance and Non-Performance (150 mW) Radios in the Same Network
- 3.2 Apply Power to the Gateway or Node
- 3.3 Bind Radios to Form Networks
- 3.4 LED Behavior for the Gateways
- 3.5 LED Behavior for the Nodes
- 3.6 Conducting a Site Survey (Gateway and Nodes)
- 4 Installing Your Sure Cross® Radios
- 5 Advanced Setup Options
- 5.1 DX80 Menu Structure
- 5.2 Web-based Configuration for the GatewayPro on DX83
- 5.3 Binding Mode: What does it do?
- 5.4 Setting the Network ID in Extended Addressing Mode
- 5.5 Manually Assign a Binding Code to a Gateway
- 5.6 Manually Assign a Binding Code to a Node
- 5.7 Setting the Maximum System Devices
- 5.8 Storage and Sleep Modes
- 5.9 Modbus Holding Registers
- 5.10 Modbus Communication Parameters
- 5.11 Default Output Conditions
- 5.12 Defining the Units
- 6 Product Support and Maintenance
- Index
5.1.4 SITE (Site Survey) Menu
The SITE menu displays the results of a Site Survey conducted with this Gateway.
NOD XX
M XX
R XX
Y XX
G XX
*
SITE
Single-click
Button 2
Single-click
Button 2
Double-click
Button 2
adjust right rotary
switch to survey the
selected Node
Double-click
Button 2
AUTO
DISPLAY
LOOP
Site Survey
Gateway
The SITE menu displays the device number of the Node the Site Survey was
conducted with as well as the missed, green, yellow, and red received packet
count.
The SITE menu is only available on the Gateways.
To access the SITE menu, single-click button 1 to scroll across the menu levels
until reaching the Site Survey (SITE) menu.
See Conduct a Site Survey Using the Menu System on p. 16.
See Interpreting the Site Survey Results on p. 19.
Sure Cross
®
Performance DX80 Wireless I/O Networks
34 www.bannerengineering.com - Tel: + 1 888 373 6767