Instruction Manual

Ethernet Ethernet is an access method for computer network (Local Area Networks) communications, defined by
IEEE as the 802 standard.
EtherNet/IP
™
EtherNet/IP is Allen-Bradley’s DeviceNet running over Ethernet hardware.
extended
address mode
Using extended address mode isolates networks from one another by assigning a unique code, the
extended address code, to all devices in a particular network. Only devices sharing the extended
address code can exchange data. The extended address code is derived from the Gateway's serial
number, but the code can be customized using the manual binding procedure.
flash pattern Flash patterns are established by selecting timeslots to turn the output on or off. While originally the
flash pattern was designed to turn on and off an indicator light, the flash pattern can be set for any
discrete output or switch power output.
Flex Power Banner’s Flex Power
®
technology allows for a true wireless solution by allowing the device to operate
using either 10 to 30 V DC, 3.6 V lithium D cell batteries, or solar power. This unique power
management system can operate a Flex Power Node and an optimized sensing device for up to 5 years
on a single lithium D cell.
free space loss
(FSL)
The radio signal loss occurring as the signal radiates through free space. Free Space Loss = 20 Log
(4(3.1416)d/λ ) where d is in meters. Remembering that λf = c = 300 x 10
6
m/s, the equations reduce
down to:
For the 900 MHz radio band: FSL = 31.5 + 20 Log d (where d is in meters).
For the 2.4 GHz radio band: FSL = 40 + 20 Log d (where d is in meters.)
Frequency
Hopping Spread
Spectrum
(FHSS)
Frequency Hopping Spread Spectrum (FHSS) is a method for generating spread spectrum
transmissions where the signal is switched between different frequency channels in a pseudo-random
sequence known by both the transmitter and the receiver. FHSS is useful for sending small packets of
data in a high interference environment.
902 MHz 928 MHz
1 2 3
25 26 27
. . . . . . . . . . . . . . . . . . . .
Frequency
Power
Fresnel zone Fresnel zones are the three-dimensional elliptical zones of radio signals between the transmitter and
receiver. Because the signal strength is strongest in the first zone and decreases in each successive
zone, obstacles within the first Fresnel zone cause the greatest amount of destructive interference.
1st Fresnel Zone
2nd Fresnel Zone
3rd Fresnel Zone
Tx
Rx
gain Gain represents how well the antenna focuses the signal power. A 3 dB gain increase doubles the
effective transmitting power while every 6 dB increase doubles the distance the signal travels.
Increasing the gain sacrifices the vertical height of the signal for horizontal distance increases. The
signal is ‘squashed’ down to concentrate the signal strength along the horizontal plane.
gateway A gateway is a general network device that connects two different networks.
Gateway A Sure Cross
®
Gateway is the wireless sensor network master device used to control network timing
and schedule communication traffic. Similar to how a gateway device on a wired network acts as a
"portal" between networks, the Sure Cross Gateway acts as the portal between the wireless network
and the central control process. Every wireless I/O sensor network requires one Gateway device. Every
Sure Cross device is a transceiver, meaning it can transmit and receive data.
GatewayPro The GatewayPro combines the standard Gateway and the DX83 Ethernet Bridge into one device.
ground loop Ground loops are grounds within a system that are not at the same potential. Ground loops can damage
electrical systems.
Sure Cross
®
Performance DX80 Wireless I/O Networks
www.bannerengineering.com - Tel: + 1 888 373 6767 61