Owner manual

D11E Series
page 4 Banner Engineering Corporation
Push Button Indicator Status
Push and hold for ≥ 2 seconds
Push and Hold ≥ 2 Seconds
Green: Flashes at 1Hz
Yellow: Off
Red: Pulses to indicate relative received signal
strength
PULSE STRETCHER
Double-click to display status
Single-click to toggle pulse
stretcher "on" or "off"
Double-Click
Single-Click
pulse stretcher "ON":
Green: Off
Yellow: Off
Red: On steadily
pulse stretcher "OFF":
Green: Off
Yellow: Off
Red: Double-Flash
Double-Click
Double-click to save configuration
and return to RUN mode
See page 2
Output Pulse Stretcher
A 40 millisecond pulse stretcher (OFF-delay) may be enabled for applications where a very short sensing event might be missed
due to the response of the load or input connected to the sensor output. The pulse stretcher is turned "on"or "off" using the
following procedure: