User guide

Banner Engineering Corp., 9714 Tenth Ave. No., Minneapolis, MN 55441 • Phone: [phone] • www.baneng.com • E-mail: [e-mail]
D11 Sensors
– Visible Green, Blue or White LED Light Source
WARRANTY: Banner Engineering Corp.
warrants its products to be free from
defects for one year. Banner
Engineering Corp. will repair or replace,
free of charge, any product of its
manufacture found to be defective at
the time it is returned to the factory
during the warranty period. This
warranty does not cover damage or
liability for the improper application of
Banner products. This warranty is in
lieu of any other warranty either
expressed or implied.
D11 Series Dimensions
Sensitivity
Adjustment
Power Indicator
Output Indicator
Plastic Fiber
Emitter Port
Plastic Fiber
Receiver Port
Mounting
Bracket
(Included)
35.0 mm
(1.38")
17.6 mm
(0.69")
64.1 mm
(2.53")
11.0 mm
(0.43")
29.0 mm
(1.14")
Slide Up
to Release
Fibers
Sensitivity
Adjustment
Power Indicator
Output Indicator
Plastic Fiber
Emitter Port
Plastic Fiber
Receiver Port
Mounting
Bracket
(Included)
35.0 mm
(1.38")
17.6 mm
(0.69")
64.1 mm
(2.53")
77.7 mm
(3.06")
11.0 mm
(0.43")
29.0 mm
(1.14")
Slide Up
to Release
Fibers
37.1 mm
(1.46")
26.2 mm
(1.03")
31.2 mm
(1.23")
5.0 mm
(0.20")
10.9 mm
(0.43")
2 x C 'sink
ø 7.9 mm (0.31")
3.2 mm (0.13") deep
ø4.4 (0.18") thru
2 x ø 3.25 mm
(0.128")
2 x 3.5 mm
(0.14")
5.5 mm
(0.22")
11.0 mm
(0.44")
26.5 mm
(1.05")
10.5 mm
(0.42")
2.5 mm
(0.10")
8.6 mm
(0.34")
5.8 mm
(0.23")
2 x ø 3.18 mm
(0.125")
Cabled Models
Quick-Disconnect Models
Mounting Bracket
Fiber Adaptor
Plastic Fiber Installation:
1. Cut fiber ends per instructions
included with the fibers. Slide the
fiber gripper up (open). For 0.25 mm
or 0.5 mm diameter fibers, insert the
adapter (shown below) into the ports
as far as it will go.
2. All fibers: Insert the prepared plastic
fiber sensor ends gently into the
ports as far as they will go.
3. Slide the fiber gripper back down to
lock.
Adaptor (included) is for use with
0.25 mm (0.01") or 0.5 mm (0.02")
diameter fibers