User Manual

D11E Series Sensors
– Visible Green, Blue or White LED Light Source
page 7
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: [phone]
Dimensions
Programming
Push Button
Power Indicator
Output Indicator
Signal Strength
Indicator
ø 1.0 mm (0.04 in)
Plastic Fiber
Emitter Port
ø 1.0 mm (0.04 in)
Plastic Fiber
Receiver Port
Mounting
Bracket
(Included)
35.0 mm
(1.38")
17.6 mm
(0.69")
64.1 mm
(2.53")
11.0 mm
(
0.43"
)
29.0 mm
(1.14")
Slide Up
to Release
Fibers
Programming
Push Button
Power Indicator
Output Indicator
Signal Strength
Indicator
ø 1.0 mm (0.04" )
Plastic Fiber
Emitter Port
ø 1.0 mm (0.04")
Plastic Fiber
Receiver Port
Mounting
Bracket
(Included)
35.0 mm
(1.38")
17.6 mm
(0.69")
64.1 mm
(2.53")
79.0 mm
(3.11")
11.0 mm
(0.43")
29.0 mm
(1.14")
Slide Up
to Release
Fibers
35.0 mm
(1.38")
25.1 mm
(0.99")
30.2 mm
(1.19")
5.0 mm
(0.20")
9.9 mm
(0.39")
2 x C 'sink
ø 7.9 mm (0.31")
3.2 mm (0.13") deep
ø4.4 (0.18") thru
2 x ø 3.25 mm
(0.128")
2 x 3.5 mm
(0.14")
5.5 mm
(0.22")
11.0 mm
(0.44")
25.6 mm
(1.01")
9.6 mm
(0.38")
2.5 mm
(0.10")
8.6 mm
(0.34")
4.8 mm
(0.19")
2 x ø 3.18 mm
(0.125")
Cabled models
Quick disconnect models
Mounting Bracket DIN Rail Mounting
Fiber Adaptor
Plastic Fiber Installation:
1. Cut fiber ends per instructions
included with the fibers. Slide the
fiber gripper up (open). For 0.25 mm
or 0.5 mm diameter fibers, insert the
adapter (shown below) into the ports
as far as it will go.
2. All fibers: Insert the prepared plastic
fiber sensor ends gently into the
ports as far as they will go.
3. Slide the fiber gripper back down to
lock.
Adaptor (included) is for use with
0.25 mm (0.01") or 0.5 mm (0.02")
diameter fibers
DIN Rail