Instruction manual

5 Remote Input (not available on IO-Link models)
The remote input may be used to perform TEACH/SET methods and to program the sensor remotely. Connect the white
input wire of the sensor to ground (0 V dc), with a remote switch connected between them. Pulse the remote input
according to the diagram shown in Figure 4 on page
12. Follow the instructions in the TEACH/SET sections in Adjust
Mode on page 13 to perform a TEACH/SET method.
The sensor exits TEACH and remote programming modes after a 60 second timeout. Users may exit TEACH and remote
programming modes by setting the remote input low for more than 2 seconds. In either case, the sensor returns to Run
mode without saving any new settings.
Figure 4. Remote Input Flowchart
DF-G1 Expert
™
Dual Display Fiber Amplifier
12