User Manual

Datasheet

• 1.5 mm (0.06") clear polycarbonate

• Neoprene foam gasket

• Easy to install

• Available in sizes for all EZ-SCREEN Type 2 emitter and receiver

models

Lens Shield Models Fits EZ-SCREEN Type 2 HD Models Lens Shield Lengths

LSS-150 LS2..30-150 210 mm

LSS-300 LS2..30-300 360 mm

LSS-450 LS2..30-450 510 mm

LSS-600 LS2..30-600 660 mm

LSS-750 LS2..30-750 810 mm

LSS-900 LS2..30-900 959 mm

LSS-1050 LS2..30-1050 1109 mm

LSS-1200 LS2..30-1200 1558 mm

LSS-1350 LS2..30-1350 1708 mm

LSS-1500 LS2..30-1500 1858 mm

Description

The model LSS-.. Lens Shield is a replaceable protective cover for the lens of an EZ-SCREEN Type 2 sensor.

The shield is made of 1.5 mm (0.06 inch) thick clear polycarbonate to protect the emitter or receiver lens from damage

from weld flash or impact.

Shield models are available for every sensor length and attach to the sensor with an adhesive-backed Neoprene foam

gasket.

Application Note: When shields are installed on both the emitter and receiver, excess gain is reduced by 36 percent and

maximum operating range is reduced by 20 percent.

EZ-SCREEN Type 2 Lens Shields

P/N 121366 Rev. A 16 December 2013

0 121366 9

PAGE 1
EZ-SCREEN Type 2 Lens Shields Datasheet • • • • 1.5 mm (0.06") clear polycarbonate Neoprene foam gasket Easy to install Available in sizes for all EZ-SCREEN Type 2 emitter and receiver models Lens Shield Models Fits EZ-SCREEN Type 2 HD Models Lens Shield Lengths LSS-150 LS2..30-150 210 mm LSS-300 LS2..30-300 360 mm LSS-450 LS2..30-450 510 mm LSS-600 LS2..30-600 660 mm LSS-750 LS2..30-750 810 mm LSS-900 LS2..30-900 959 mm LSS-1050 LS2..30-1050 1109 mm LSS-1200 LS2..
PAGE 2
EZ-SCREEN Type 2 Lens Shields Installing the Lens Shield Remove all dust, dirt, and oil from the metal surfaces on all four sides of the emitter or receiver lens, using a mild detergent or window cleaner and a soft cloth. Also clean the sensor lens, if needed. NOTE: Avoid cleaning agents containing alcohol, as they will damage the sensor’s acrylic lens.