Engineering Power Supply Specification Sheet

ManualsBrandsBanner ManualsPower SupplyFlexPower DX81P6

SureCross™ DX81P6 FlexPower™ Supply Module

Delivers and manages dc voltage from six 3.6V dc lithium primary batteries

Printed in USA 01/08 P/N 131628 rev. B

WARNING . . .

Not To Be Used for Personnel Protection

Never use these products as sensing devices for personnel protection. Doing so could lead to serious injury or death.

These sensors do NOT include the self-checking redundant circuitry necessary to allow their use in personnel safety applications. A

sensor failure or malfunction can cause either an energized or de-energized sensor output condition. Consult your current Banner

Safety Products catalog for safety products which meet OSHA, ANSI and IEC standards for personnel protection.

Model Power Batteries Cable

DX81P6 3.6V dc Battery Six 3.6V lithium “D” Cells 5-pin Euro Pigtail QD

Models

Features

Wireless solution for powering a FlexPower™ Node and sensor devices

Unique power management system to run the FlexPower Node and a device through

switched power outputs for up to ten years, depending on the power requirements of

the device and required update rates

Six 3.6V dc lithium “D” cell batteries

IP67 sealed enclosure

FlexPower systems allow for a true wireless solution as the Node can be powered by battery

power (3.6 to 5.5V dc). Battery life is application speciﬁc. Contact Banner Engineering’s

application engineers for a battery life calculation for your speciﬁc application.

For additional information and a complete list of replacement parts, please refer to Banner

Engineering’s website, www.bannerengineering.com/surecross.

•

Summary of content (4 pages)

PAGE 1
SureCross™ DX81P6 FlexPower™ Supply Module Delivers and manages dc voltage from six 3.6V dc lithium primary batteries Features • Wireless solution for powering a FlexPower™ Node and sensor devices • Unique power management system to run the FlexPower Node and a device through switched power outputs for up to ten years, depending on the power requirements of the device and required update rates • Six 3.
PAGE 2
SureCross™ DX81P6 FlexPower™ Supply Module Battery Replacement Battery Replacement To replace the lithium “D” cell battery pack in the DX81P6 FlexPower™ battery kit, 1. Remove the four screws mounting the clear plastic battery pack cover to the housing. 2. Remove the cover and foam spacer. 3. Disconnect the discharged battery pack. 4. Remove the discharged battery pack and replace with a new battery pack. Caution: There is an explosion risk if the battery pack is replaced with an incorrect type. 5.
PAGE 3
SureCross™ DX81P6 FlexPower™ Supply Module Specifications General Mounting #1/4 or M7 (M7 hardware included) M7 fasteners – Max. Tightening Torque 0.56 N•m (5 in•lbf) Case Material Polycarbonate Weight 0.98 kg (2.15 lb.) External Cable Glands One 1/2 NPT type Cable Glands, Max Tightening Torque 0.
PAGE 4
SureCross™ DX81P6 FlexPower™ Supply Module Dimensions 195.9mm [7.71"] 148.1mm [5.83"] 87.6mm [3.45"] 55.9mm [2.20"] 138.2mm [5.44"] 20.1mm [0.79"] The manufacturer does not take responsibility for the violation of any warning listed in this document. CAUTION . . . Make no modifications to this product. Any modifications to this product not expressly approved by Banner Engineering could void the user’s authority to operate the product. Contact the Factory for more information.