Manual

L-GAGE Q50 Analog Output Sensor Specifications (continued)
L-GAGE Q50 Dimensions
L-GAGE Q50 – Analog Output Sensor
page 7
Banner Engineering Corp. • Minneapolis, U.S.A.
www.bannerengineering.com • Tel: [phone]
19.7 mm
(0.77")
60.0 mm
(2.36")
4.0 mm
(0.16")
4.0 mm
(0.16")
41.8 mm
(1.65")
52.0 mm
(2.05")
77.0 mm
(3.03")
49.8 mm
(1.96")
67.3 mm
(2.65")
2x ø3.4 mm
(0.13")
25 mm
(0.98")
15 mm
(0.59")
15 mm
(0.59")
RANGE
IN OUT
TEACH OUTPUT
bn
bu
bn
bu
gy
bk
response
Teach
wh
15-30V dc
5-30V dc
4ms
+5-30V dc
Bar
e
0-2V dc
64ms
+
–
Load
L-
G
A
GE
™
Q50BUQ
RANGE: 100 - 400mm
bn
bu
bn
bu
gy
bk
response
Te a c h
wh
15-30V dc
5-30V dc
4ms
+5-30V dc
Bare
0-2V dc
64ms
+
–
Load
L-GAGE™
Q50BU
RANGE: 100 - 400mm
To Set NEAR and FAR Limits.
1. Press and hold Teach button until the
Te ach light turns on (RED)
2. Adjust target to 1st limit position.
Press Teach button. (Teach flashes)
3. Adjust target to 2nd limit position.
Press Teach button (Teach turns off)
Emitter
Receiver
bn
bu
bn
bu
gy
bk
Response
T
each
wh
15-30V dc
5-30V dc
4ms
+5-30V dc
Bare
0-2V dc
64ms
+
–
Load
15-30V dc
+
–
bn
bu
gy
bk
Response
T
each
wh
+5-30V dc
Bare
Load
5-30V dc
4ms
0-2V dc
64m
s
Connections 2 m or 9 m 5-conductor PVC-covered attached cable or 5-pin Euro-style quick disconnect
Construction Housing: Molded ABS/Polycarbonate
Window Lens: Acrylic
Environmental Rating IEC IP67, NEMA 6
Vibration and
Mechanical Shock
All models meet Mil. Std. 202F requirements. Method 201A (Vibration: 10 to 60Hz max. double amplitude
0.06", maximum acceleration 10G). Also meets IEC 947-5-2 requirements: 30G, 11 ms duration, half sine
wave.
Operating Conditions Temperature: -10° to +55°C (+14° to +131°F)
Max. Rel. Humidity: 90% at +50°C (non-condensing)
Application Notes Allow 15-minute warm-up for maximum linearity.
Hardware M3 hardware is included.
L-GAGE Q50 Hookups
Cable Models
Quick-Disconnect Models