User Manual

Character Connectivity Calibration
Intra-Character Connectivity defines the maximum number of pixel spaces between two character strokes so
that both strokes will be considered part of the same character. In the example below, if the Horizontal Gap
were defined too small, the "H" could be considered an I - I.
Note: Here "0" vertical gap really means "infinite" vertical gap (but bounded by the ROI); that
is, all pixels in a vertical line can be considered part of the same character.
Parameters
The following are the parameters that you adjust to set Intra-Character Connectivty.
Additional InformationDescriptionIntra-Character Connectivity
Use the up or down arrow
controls to set the maximum
Max Horizontal Gap
P/N 000000Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Tel: [phone]
132
7/2009PresencePLUS Software Tools