User Manual

5. Start the sofware.
6. Upon initial startup, the software communication is not configured, and the following error message
is displayed.
7. Click Yes to open the Communication screen.
8. Establish communications as follows:
Ethernet
Connection
1. When the software is started for the first time, the IP address is "Localhost."
Choose Ethernet (RJ 45).
2. Change the IP address to 192.168.0.1 (default IP address of the sensor).
3. Click OK.
23Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Tel: [phone]
P/N 000000
Getting Started7/2009