User Manual
6
System Setup Window Overview
To access the System Setup window, click the System button in the Main Menu toolbar on the applcation window.
To clear changes, click Cancel. To save changes and exit the System Setup window, click OK.
To exit the System Setup window without changes, click the X in the upper-right corner of the window.
Note: To make changes to the sensor selections, an inspection must not be running. To stop a running
inspection, click the Stop button in the Run tab. To save changes, click OK before exiting the tab or
closing the window.
The System Setup Window includes the following tabs:
•
Sensor Select Tab6.1 Sensor Select Tab on page 46
•
Communication Tab6.2 Communication Tab on page 51
•
Input/Output Tab
•
Strobe Tab6.4 Strobe Tab on page 84
•
Units Tab6.5 Units Tab on page 85
•
Reset Tab6.6 Reset Tab on page 86
•
Start-Up Inspection Tab6.7 Start-Up Inspection Tab on page 87
•
NTSC Tab6.8 NTSC Tab on page 89
•
Language Tab6.9 Language Tab on page 90
•
Tools Configuration6.10 Tools Configuration on page 91
System Setup Window
P4 System Setup Window
45Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Tel: 763.544.3164
P/N 000000