User Manual

DescriptionField
If the Icon is green (Yes), the sensor is available; if yellow, a connection can't be
established for some reason; if red (No), the sensor is not available.
Available
Note: The sensor to which you are currently connected will sho up as unavailable
(red icon).
The name of the sensor.Name
The IP address assigned to the sensor.IP Address
The sensor model and type.Product ID
The sensor version.Sensor Version
Indicates whether the sensor is running or not.Running
Inspection
Indicates whether there is an error condition associated with the sensor.Error
The MAC address of the sensor.MAC
PC (GUI) to Sensor Connection Setup
This selection is used to configure the communication link between the GUI (Graphical User Interface) and
the sensor. There are two possible selections, Ethernet (RJ45) and Serial:
• Ethernet (RJ45)
This selection will configure the GUI to communicate with the sensor using the Ethernet (RJ45) connection.
To establish communication you must enter the IP address of the sensor you would like to communicate with
into the "Connection IP Address" edit box or select the desired Sensor from the Sensor Neighborhood results.
Then, click on the "OK" button to connect.
• Serial
This selection will configure the GUI to communicate with a sensor via the Serial connection. To establish
communication you must first start Dial-Up Networking (DUN) on the PC. Then, click on the "OK" button to
connect.
Sensor Select Tab
47Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Tel: [phone]
P/N 000000
System Setup Window Overview7/2009