User Guide

Quick Start Guide
This guide is designed to help you set up and install the R45C Analog Output to IO-Link Device Converter. For complete information on
programming, performance, troubleshooting, dimensions, and accessories, please refer to the Instruction Manual at www.bannerengineering.com.
Search for p/n 223052 to view the Instruction Manual. Use of this document assumes familiarity with pertinent industry standards and practices.
• Compact analog to IO-Link device converter that outputs an analog value, voltage or
current, as presented by the IO-Link Master
• Rugged over-molded design meets IP65, IP67, and IP68
• Connects directly to a sensor or anywhere in-line for ease of use
Overview
Analog Out
This converter allows for the user to output an analog value by sending the numerical analog value from the IO-Link Master via Process Data Out
(PDO).
PDO Analog Ranges:
• Voltage = 0 mV to 11,000 mV
• Current = 0 µA to 24,000 µA
PDO Outside Valid Range (POVR)
If the PDO value sent to this converter is outside of the PDO Analog Range value, then the actual analog output value will be set to the one of the
three selectable POVR levels after a 2 second delay:
• Low (default): 0 V or 3.5 mA
• High: 10.5 V or 20.5 mA
• Hold: Level retains previous value indefinitely
Note: If a connected IO-Link sensor is changed back to SIO mode, then the previous value will be held.
Status Indicators
The R45C Analog Output to IO-Link Device Converter has two amber LED indicators on both sides for IO-link and analog communications to allow
for installation needs and still provide adequate indication visibility. There is also a green LED indicator on both sides of the converter, which signals
the device's power status.
IO-Link Amber LED
Indication Status
Off IO-Link communications are not present
Flashing Amber (900 ms On, 100 ms Off) IO-Link communications are active
Analog Out Amber LED
Indication Status
Off Turns off if written PDO analog value is outside the allowable output range
Solid Amber Turns on if written PDO analog value is inside the allowable output range
Allowable Current Range: 0 mA to 24 mA
Allowable Voltage Range: 0 V to 11 V
Mechanical Installation
Install the R45C to allow access for functional checks, maintenance, and service or replacement. Do not install the R45C in such a way to allow for
intentional defeat.
All mounting hardware is supplied by the user. Fasteners must be of sufficient strength to guard against breakage. Use of permanent fasteners or
locking hardware is recommended to prevent the loosening or displacement of the device. The mounting hole (4.5 mm) in the R45C accepts M4 (#8)
hardware. See the figure below to help in determining the minimum screw length.
12.9 mm
NUT
3.9 mm
3 mm *
for minimum
engagement
of
three threads
Screw Length (with screw head fitting in counterbore) = 12.9 mm + “X” mm + 3 mm
X
*
R45C Analog Output to IO-Link Device Converter
Original Document
227115 Rev. A
10 December 2021
227115