Owner's manual

P/N 129317 rev. D 3
Banner Engineering Corp.•Minneapolis,MNU.S.A
www.bannerengineering.com•Tel:763.544.3164
SureCross™ DX80K Wireless Configured Kit
Device Configuration
Switches
Device Settings 1 2 3 4
Rotary Switch Address Mode OFF*
Extended Address Mode ON
* Default configuration
Analog (Sourcing) Input Wiring
(10 to 30V dc power)
Analog (Sourcing) Output Wiring
PWR
AIx
*
* Do not exceed analog input ratings for analog
inputs. Only connect sensor outputs to analog inputs.
AOx
GND
+10 to 30V dc
Do not change the position of any DIP switch
other than DIP switch 1. This kit is configured
at the factory.
Cycle Power
After making any changes to the DIP switch positions, cycle power
to the device to activate the changes. For devices with batteries
integrated into the housing, remove the battery for one minute to
cycle power to the device.
Accessing the DIP Switches
ToaccesstheDIPswitches,followthesesteps:
Unscrew the four screws that mount the cover to the bottom 1.
housing.
Remove the cover from the housing without damaging the 2.
ribbon cable or the pins the cable plugs into.
Gently unplug the ribbon cable from the board mounted into 3.
the bottom housing.
Remove the black cover plate from the bottom of the 4.
device’s cover.
The DIP switches are located behind the rotary dials. After making the
necessary changes to the DIP switches, place the black cover plate
back into position and gently push into place. Plug the ribbon cable
in after verifying that the blocked hole lines up with the missing pin.
Mount the cover back onto the housing.
Address Mode
The SureCross wireless devices may use one of two types of
addressingmodes:rotaryswitchaddressingorextendedaddressing.
In rotary switch address mode, the left rotary dial establishes the
network ID and the right rotary dial sets the device ID. The wireless
networkisrestrictedtoamaximumof16devices.
Extended address mode binds Nodes to a specific Gateway, allowing
networkexpansiontomorethan16devicesinawirelessnetwork.
For more information on extended address mode, refer to the
SureCross™ Wireless I/O Network product manual.
The device ships in rotary switch address mode by default, with the
DIP switch in the OFF position. To use extended address mode,
change the DIP switch to the ON position.