User Manual

Banner Engineering Corp.•Minneapolis,MNU.S.A

www.bannerengineering.com•Tel:763.544.3164

4 P/N 129311 rev. D

SureCross™ DX80K Wireless Conﬁgured Kit

Do not change the position of the right rotary dial on the Node(s) in this kit. The factory conﬁgured this kit and assigned a device ID to the

Node(s) based on the kit conﬁguration requirements. If you change the Node’s right rotary dial, your kit will not work.

Rotary Dial Positions

Rotary Dial Addressing Mode

When using Rotary Dial Addressing Mode, the Gateway’s and Node’s rotary dials are in the correct position. The left rotary dial establishes the

Network ID and the right dials establish the Device ID.

When using multiple networks within range of each other, set each network to a different Network ID using the left rotary dial. DO NOT change

the position of the right rotary dials or your network and its preconﬁgured mapping will not work.

Gateway rotary dial positions, from the

factory.

Node rotary dial positions, from the

factory.

Extended Addressing and Binding Mode

When using binding to establish your networks, the rotary dial positions on the Gateway indicate which Node’s I/O values are displayed on the

Gateway’s LCD. Adjust the left rotary dial to zero and the right rotary dial to one.

For the Nodes, set the left rotary dial position to zero, and DO NOT change the position of the right rotary dial or your network and its

preconﬁgured mapping will not work.

Gateway rotary dial positions.

Node 1’s rotary dial positions.